How to disassemble the wired Xbox 360 controller

2.As shown in the diagram, take off the internal parts.

3.As shown in the diagram, take off these 2 screws.

4.Insert the screw driver into the holes then press

5.remove the rubbers and the buttons as shown in the picture.

6.As shown in the diagram,remove the RT ,LT buttons.

7.disassembly is completed.

How to install the wired XCM 360 controller shell

9.As shown in the diagram, install the RT and LT buttons step by step.

10.Screw the direction button back to the shell, place the rubber on.

11.As shown in the diagram, solder these 3 wires.

12.Close the controller bottom,put on those screws.

13.Installation complete.

14.Switch to ● for turning on the controller LED light, Switch to ○ for turning off the controller LED light.

1.As shown in the diagram,using the XCM screw driver to take off the 7 screws as indicated.

8.XCM RT and LT buttons.