How to install the XCM controller shell to new version of 360 wireless controller (Picture 1-5)

Page 1 , 2 , 3

1.As shown in the diagram, take off the battery pack and using the XCM screw driver to take off the 7 screws as indicated.

2.As shown in the diagram, take off the internal parts.

3.As shown in the diagram, take off these 2 screws.

4.Insert the screw driver into the holes then press.

5.Remove the rubbers and the buttons as shown in the picture.

Page 1 , 2 , 3

Back to 360 page

Back to Home page