How to install the XCM controller shell to new version of 360 wireless controller (Picture 11-15)

Page 1 , 2 , 3

11.As shown in the diagram, solder these 3 wires.

12.As shown in the diagram, push the back of on-live button close to this point, make sure the button working properly before closing the controller bot.

13.Close the controller bottom,put on the 7 screws then cover the battery pack back to the place.

14.Installation complete.

15.LED light button (on/off the LED light)

Page 1 , 2 , 3

Back to 360 page

Back to Home page